Helios EHSAFE20AL 2kW ATEX Approved IR Heater

• Single element
• IP66 rating
• Easy to fit tilt and swivel mounting bracket
• Gold quartz halogen element for neutral light output
• Optically designed parabolic reflector for maximum heat output
• Rugged powder-coated mild-steel enclosure

Compared with other types of ATEX compliant heaters, the EHSAFE20AL has the benefit of emitting radiant short-wave infrared heat, so will not be affected by air movement. Provides a very high heat output for the power rating due to the large parabolic reflector. Other ATEX-approved heaters work by warming the air whereas this heater delivers shortwave infrared, making it ideal for heating very dusty, hazardous, cold, damp and draughty workplaces. It is particularly suited to ATEX areas where high ventilation rates are needed to extract fumes and/or hazardous dust particles —areas where attempting to warm people by warming the air would be impractical.  The fact these heaters create zero air movement is a huge benefit, particularly within very dusty environments or spray booths with high extraction.

EHSAFE20AL is both dust tight and impervious to strong direct water jets (IP66). The heavy-duty cast aluminium heat-sink enclosure is designed to dissipate away surplus heat for maximum reliability. Features a high-emissivity ROBAX glass front and a substantial tilt and swivel mounting bracket. Four M6 threaded suspension points are included to enable the heater to be suspended from chains. Typical heated area is 20m².

ATEX Compliance:

• EHSAFE20AL
  II 3G Ex ec IIC T2 Gc
  II 3D Ex tc III B T290°C Dc IP66 -5°C ≤ Ta ≤ +25°C
  (1.5kW version available to order – ref. EHSAFE15AL)

Construction:

• Die-cast aluminium, oven epoxy powder coating
• Extra-pure, buffed, anodically oxidised aluminium parabolic reflector
• Front (ceramic glass)
• Stainless Steel AISI 316 safety valve
• Silicone rubber seal
• Supply cable: 1.5m, resistant to 180°C
• Adjustable wall anchorage

Warning:
Please note: This heater is suitable for installation in explosive atmosphere conditions, classified zone 2-22, pursuant to directives 94/9 and 99/92 EC ATEX.
Zone 2-22 indicates that the atmosphere, which is normally not explosive during routine use, may, on rare occasions, briefly become explosive (generally in the presence of a malfunction). The heater therefore cannot be installed in zones other than those classed as ZONE 2-22. T2 indicates that the ignition temperature of the flammable gasses of the classified zone must be higher than 300°C. The table below (from EN 13463-1) lists other temperature classes.

Please note, standard controls will need to be mounted outside the ATEX zone. ATEX-rated controls available as a bespoke request.

230v and 110v versions available. Please note that the 110v version is 1.5kW and is made to order.

Replacement element: 15005z-al